Constant Sleeve Series
Basic and inexpensive all steel variety of gear coupling constructed that has a single sleeve and two hubs
Comparatively simple set up
Precision minimize 20° stress angle gear teeth with minimum backlash
Most typical configurations are available as stock things
Angular misalignment of 1/2° per gear mesh (flex-plane)
Sizes 7/8 by 12, to accommodate bore sizes as much as and which includes twelve.50 inches
Interference fit (conventional) and Clearance match on bores can be found
Load Capacities range from two,500 in-lbs up to two,520,000 in-lbs
Styles for applications requiring horizontal and vertical orientation, full-flex, flex-rigid, mill-motor, disengagement, sliding hubs, Shear Pin, floating shaft, and spacers
Patented and tested BUNA N seal style with reinforced washers bonded for the within edges which positively retain lubricant and seal the interior from outdoors contaminants
Reinforced rubber seals with snap rings to hold in lubricant
Two snap rings made of hardened spring steel which securely hold the coupling with each other, are effortless to put in or take away, however withstand a hundred,000 pounds of finish thrust
Inch and Metric bore sizes obtainable
Flanged Sleeve Series
Patented tooth kind for long coupling life
Precision cut 20° pressure angle gear teeth with minimal backlash
All steel sleeves and hubs (stainless steel readily available)
Models for applications requiring horizontal and vertical orientation
Most normal configurations can be found as stock objects
Angular misalignment of 1-1/2° per gear mesh (flex-plane) as much as size 5.five, 3/4° for sizes 6 and over
Coupling sizes offered via dimension thirty to accommodate bore sizes up to and together with 44 inches
Interference fit (regular) and Clearance fit on bores can be found
Load capacities range from seven,600 in-lbs as much as 47,269,000 in-lbs
Exposed bolts standard on all sizes, shrouded offered by request as much as size six
Standard bolts provided are taken care of to become corrosion resistant
Flanged sleeve couplings are interchangeable with field standards
Piloted gear match for greater speeds and less vibration
Labyrinth all steel seal layout in FL series
Inch and Metric bore sizes available
Common Varieties and Sizes
Sier-Bath couplings are stocked in an assortment of configurations which contain C and F common hubs and sleeves, Mill Motor hubs, Vertical type, Floating Shaft, and Spacer styles. ’s exceptional engineering employees make it attainable to support lots of further coupling sorts such because the Brakedrum variety, Sliding Hub form, Shear Pin variety, Jordan kind, and custom lengths for non normal shaft separations. Further size ranges and models to meet unusual application specifications could also be manufactured by to meet market place demands. Material can range from normal steel to alloy steel as well as stainless steel. The excellent simplicity of the coupling style and design make this all attainable.
Misalignment and End-Float Capability
The basic principle of Sier-Bath C and F kind couplings is just like that of other conventional flexible gear couplings. Even though it truly is desirable to align shafts as accurately as possible, the objective of any versatile coupling should be to absorb probable angular, parallel, and axial (end-float) misalignment. Sier-Bath couplings use a one of a kind gear tooth geometry produced exclusively to resolve concerns with shaft misalignment and accommodate from 1/2° to 1-1/2° per gear mesh or flex plane. The hub teeth are absolutely crowned to provide for any larger make contact with region and reduced stresses below misaligned ailments. The crowned tooth design and style also eliminates almost all of the finish loading that takes place on straight gear teeth underneath misalignment.