Worm Gear electric ball screw jack, anti-Rotation and higher pitches available
Translating(traveling screw) and rotating (traveling nut) configurations
Move loads and apply force more efficiently than various other machine screw actuators
No self-locking! Because of the lack of friction, a holding brake is essential: a engine brake or a spring pressure brake is required.
These worm equipment screw jacks are very Worm Gear Jack precision and reliability, it could meet all the necessary basic safety, cost-efficiency, and strength mandates of the application. High strength bronze worm gear is used, the payloads from 0.5T to 100T . A total of 11 sizes can be found, each in a vacationing nut version and a basic version.

The screw jacks can be utilized separately or in organizations connected with drive shafts, joints, couplings, bevel gearboxes and various other mechanical components. In addition they could be powered by different motors: electrical, with either AC electric motor or DC motor along with hydraulic or pneumatic motors. Each one of these motion control products could be built-in many type jacking program arrangements or configurations.
Ball screw jacks are normal where higher speeds and duty cycles are needed. Most screw jacks use trapezoidal screws Tr, because they’re simple, robust and inexpensive. The proportion of screw jacks that make use of ball screws is however constantly increasing. The reasons for this are mainly their pitch precision, their high efficiency (less power consumption and much less heat era) and the higher pitches obtainable, which permit higher stroke speeds.

A screw jack can truly add a machine cut lifting nut. Because of this model screw jack, just the bronze nut move along with the screw shaft. The lifting screw will not slide. It is similar to the linear actuator functioning principle which converts rotational movement into linear motion. Out of this point to understand, a power linear actuator is a motorized screw jack.

The screw thread of screw jack can be acme screw and ball screw. So there are few variations of the screw jack. Commonly, machine screw jack and ball screw jack are available in your engineer task. Compared with acme screw, the ball screw is definitely better as there are ball bearings between the nut and screw. The anti-friction ball bearing can raise the ball screw efficiency.