Electrical power UNITS FOR LIFT TABLE

by | Jan 20, 2021 | agriculturalchain

Energy UNITS FOR LIFT TABLE 1
Basic Description
This energy unit is developed solely to the tiny lift table,Consisting of higher pressure gear pump, AC motor, multi-functional manifold, valves, tank, etc. This energy unit has become widely utilised during the sector of logistic devices including minifork lift, scissors lift and ariel functioning platforms. The lower-ing movement is controlled by the solenoid valve with all the pace managed from the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE two
Standard Description
This power unit is created exclusively for that medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived by the solenoid valve plus the speed managed through the adjustable needle valve. When the lift rises to a higher positoin, but the electrical power provide is lower, the reducing motion is controlled by the manual override function.
Energy UNITS FOR LIFT TABLE 3
Basic Description
This energy unit is intended solely for that massive lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived from the solenoid valve as well as velocity managed by a strain compensated flow handle valve.
Electrical power UNITS FOR LIFT TABLE 4
General Description
This electrical power unit is designed exclusively to the big lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve plus the pace managed through the adjustable needle valve. Once the lift rises to a higher positoin, but the electrical power supply is reduce, the lowering movement is controlled through the manual override function.
Particular Notes
one. This energy unit is of S3 duty cycle, which can only perform intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean each of the hydraulic elements concerned before set up of the electrical power unit.
three. Viscosity of your oil shoud be 15~46 cst,which should also be clean and absolutely free of impurities.N46 hydraulic oil is advisable.
four. Oil altering is needed soon after the original a hundred operation hrs,afterwards the moment each 3000 hrs.
5. The power unit proven is built to be mounted vertically.